Powered by Blogger.

IPv6 Addressing

You are the network administrator at Ranet, and have to config Ranet-HQ (via Console Terminal) for connection t use IPv6 as below: 

    1. set IPv6 address on interface Se0/0/0 to be
       FEC0:78:0:1::2/64
    2. set IPv6 address on interface Se0/1/0 to be
       2001:21::2/48
    3. Set IPv6 address on interface Fa0/0 to be the
       gateway for Hosts in LAN as:
          3.1 Set IPv6 Local address in EUI-64 that
             has prefix to be FEC0:78:0:2::/64
          3.2 Set IPv6 Global address in EUI-64 that
             has prefix to be 2001:22::/48

If the configuration above is done,
    – Host1 will be able to connect with Ranet-BR.
    – Host2 will be able to connect with ISP-Router.
Solution: 

Ranet-HQ router config:
Ranet-HQ>en
Ranet-HQ#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Ranet-HQ(config)#ipv6 unicast-routing
Ranet-HQ(config)#int s0/0/0
Ranet-HQ(config-if)#ipv6 add FEC0:78:0:1::2/64
Ranet-HQ(config-if)#no sh
%LINK-5-CHANGED: Interface Serial0/0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0/0, changed state to up
Ranet-HQ(config-if)#int s0/1/0
Ranet-HQ(config-if)#no sh
%LINK-5-CHANGED: Interface Serial0/1/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1/0, changed state to up
Ranet-HQ(config-if)#ipv6 add 2001:21::2/48
Ranet-HQ(config-if)#int fa0/0
Ranet-HQ(config-if)#no sh
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Ranet-HQ(config-if)#ipv6 add FEC0:78:0:2::/64 eui-64
Ranet-HQ(config-if)#ipv6 add 2001:22::/48 eui-64
Ranet-HQ(config-if)#
%SYS-5-CONFIG_I: Configured from console by consoleRanet-HQ#
Ranet-HQ#copy run start
Destination filename [startup-config]? 2
Building configuration…
[OK]
Ranet-HQ#
—————– End——————
Now, Ping from Host1 to Ranet-BR and Host2 to ISP-Router is OK.
    Blogger Comment
    Facebook Comment