Below provides a short guide in configuring source NAT with an address pool on a Juniper SRX.
The following example creates a pool with a 10.1.1.0/24 network. This pool of addresses are then used during the translation of source addresses.In addition to the pool we also configure the following options:
set address-persistent - this ensures that PAT translations for a host are translated through the same IP.
set port-randomization disable - as this feature can use a large amount of resource it is disabled.
root@srx100# edit security nat source
[edit security nat source]
root@srx100# set address-persistent
root@srx100# set port-randomization disable
root@srx100# set pool nat-pool address 10.1.1.0/24
root@srx100# set rule source-nat-pool-rule match source-address 0.0.0.0
root@srx100# set rule source-nat-pool-rule then source-nat pool nat-pool
Blogger Comment
Facebook Comment